The mp-basic Kit gives you everything you need to evaluate The Bartels Pump | BP7 – Tubing in an active setup. Powered by the mp‑Multiboard2 (ESP32) and our I²C drivers, you can adjust frequency and voltage, automate operation via timer mode, and expand up to six pumps on the same board.

Key Features of mp-basic Kit:

• Ready-to-run evaluation of BP7‑Tubing micropumps
• mp‑Multiboard2 with intuitive software (frequency, voltage, timer)
• Includes three driver options (mp‑Driver, mp‑Lowdriver, mp‑Highdriver)
• Clean fluidic setup with Tygon ID 1.3 mm and mp‑hc hose clamps
• Modular and scalable to multi‑pump experiments
• USB‑powered, lab‑friendly footprint

Benefits:

• Faster proof‑of‑concepts with minimal setup time
• Flexible driver testing to match your target flow range
• Repeatable results via digital control and timer profiles
• Seamless scaling from a single pump to multi‑pump rigs
• Low total cost of testing thanks to reusable components

Areas of use:

• Life science R&D and diagnostics prototyping
• Point‑of‑care cartridge evaluation
• Microreactors, dosing and recirculation loops
• Environmental and chemical analysis
• Education and training labs

Content of the Kit:

• 3 x The Bartels Pump | BP7 – Tubing
• 1 x mp-Multiboard2 Evaluation Board (ESP32)
• 1 x mp-Lowdriver Pump Driver
• 1 x mp-Highdriver Pump Driver
• 1 x mp-Driver Pump Driver
• 1 x Tygon tubing ID 1.3 mm
• 1 x Micro-USB cable
• 10 x mp-hc Hose Clamps
• 1 x Syringe with Luer-to-Barb adapter